DIY Gun Vise

Posted on December 22, 2011 by Willy

Update 12/22/2011:

Spent a half hour and made a simple gun vise.  This was long overdue.  Very simple and basic construction.  A base board, a wood screw clamp, some scraps and some rubber to line the contact points.

This entry was posted in BPCR and tagged , . Bookmark the permalink.

2 Responses to DIY Gun Vise

  1. Willy says:
    December 23, 2016 at 7:20 pm

    Cj, thanks. Not sure what you mean by slots. I used an old wood clamp like this and ran the rear screw through a hole drilled in the upright piece of wood to form the pivot point.

    https://www.amazon.com/ATE-Pro-USA-30143-Handscrew/dp/B0006A4A5U/ref=sr_1_2?ie=UTF8&qid=1482538642&sr=8-2&keywords=wood+clamp

    Reply
  2. Cj says:
    December 21, 2016 at 4:47 am

    Very nice….how did you make the slots in the wood clamp and did you use a carriage bolt?

    Reply

Leave a Reply